if not, please repeat the above steps again. Splice kits can include many different tools to ensure a safe joint between cables.
1 10 length of 2 welding cable with a 250 amp electrode holder and a male Lenco connector 2 each Lenco.
#WELDING WIRE SPLICE KIT SERIES#
This kits are specially used for welding PU round belts, using welding clamp to fix the round belts, and can make high temperature welding, include following items:ģ.Cutter (Scissors with Skid handle) Specification:įor all kinds of PU V-belt and Round belt without cordġ) Preheating the soldering iron cutting the belt by the scissor and make sure the transverse incision is smoothĢ) Loosen the four big screws of the welding clamp, adjust the height of aluminum plates to put the belt into it.ģ) Put the open endless belt into the locating slot (If the belt size is small, adjust the four small screw of clamp to fit it, preset protruding length on both ends of the belt, make the two end belt match perfectly.Ĥ) Place the soldering iron between the ends of belt, gently tighten the clamp,make both ends completely contact soldering iron.ĥ) Heating the soldering iron, when the PU are melted approximately 0.5~1mm, whip out the soldering iron, closed the welding clamp by the side screw.Ħ) After about 3 minutes, take off the belt from the welding clamp.ħ) Grinding the surface after made the weld, check if it's finished. The innovative Wire Wizard Guide Module System utilizes a series of rollers with bearings to allow the weld wire. 100 foot of 2/0 welding cable - Made in the U.S.A.
0 kommentar(er)
